1" Raise kit for type 1   
1" transmission raise kit for street or strip use. Give your car the lowered look with out the extra camber. Down
side when going real low on a swing axle car is the outer wheel bearings do not get correct amount of oil.
With a 1 " raise kit you will raise the gearbox up but will be able to now straiten out the camber in the rear.
Rear mount is a bolt in and mid mount is a weld in.
Comes with mounting hardware.
Need help installing? We can help!

Bolt-in 1" rear raised mount only $59.99
Weld-in mid mount for stock or 1" raise only $29.99
1" raise and mid mount kit combo $84.99

Solid Mounts.
If your installing a powerful new engine then its time to step up the mounting.
The stock rubber mounts will not hold that beast in place!
Solid rear mount only
Solid nose cone mount only $13.99
Rear solid mount and solid nose kit $54.99
Rear solid, Nose solid and Mid Mount solid $79.99

Bus Nose Cone and Shift Fork to change trans over for 1" raise.
Only when mounting above 1". Places shift rod back in stock location.